

An 800 mm EC axial fan format identifies GTW080PUR23E for server and precision cooling. Listed for three-phase 380-480VAC, the model has a 2200 W input specification; exact control interfaces need confirmation.
| Rated Voltage(V) | 3`380-480 |
|---|---|
| Size(mm) | 800 |
| Input Power(W) | 2200 |
Equipment manufacturers evaluating precision cooling equipment can consider Delta GTW080PUR23E, an EC axial fan. The fan supports heat removal by keeping air moving through the selected cooling path.
The 3~380-480 V AC supply requirement gives electrical designers a clear basis for matching the fan to the equipment power architecture. Electronic commutation is part of the EC motor architecture; speed-control inputs must be checked against the complete electrical specification. Keeping inlet obstructions clear helps preserve useful airflow without spending extra power on avoidable system losses.
OEM purchasers can specify this model after checking the thermal duty, supply and mechanical fit, keeping reliable equipment operation central to selection.
In precision cooling equipment, air movement helps handle continuous temperature-control demand. Delta GTW080PUR23E supports cooling around heat-exchange sections, contributing to stable environmental conditions.
Delta GTW080PUR23E serves server and storage equipment, helping remove heat from processors, drives and other heat-producing assemblies. Airflow supports stable equipment temperatures.
In telecommunications equipment, Delta GTW080PUR23E helps remove heat from densely arranged electronic assemblies. The cooling solution addresses continuous communication duty to support service continuity.
2200 W is shown in the filter data. Check whether the corresponding datasheet defines it as rated, free-air or maximum-load input before sizing the power source.
GTW080PUR23E is listed for Server and Precision cooling. Confirm the installed airflow demand, pressure loss and ambient conditions before approval.
Isolate power first. Verify the approved supply, connector, polarity or phase, control-enable input and any obstruction; follow the exact specification and do not bypass protection circuits.
Allow for the listed 800 mm size and follow the exact mounting drawing. Keep inlet and outlet clear, use the specified fasteners and verify wiring before energizing the fan.
Serviceability depends on access, connector choice and mounting. Plan isolation and cleaning access, inspect the airflow path, and use the manufacturer's replacement guidance rather than attempting an unsupported repair.
No speed value is present in the filter row. Confirm rated speed and any control range from the exact-model specification before selection.

GTW080PUU23E is an EC axial fan listed for three-phase 380-480VAC server cooling. Its test table records 19626 m3/h at 265 Pa and 1200 rpm without a guard, providing a loaded operating point for system comparison.
Read More
The GTW091PUU23E is an EC axial fan for server and precision cooling, listed for three-phase 380-480VAC. Its PDF records 36185.9 m3/h at free air and 1100 rpm without a fan guard, identifying the test condition.
Read More
GTW091PUR22E pairs nominal 400VAC EC axial operation with a 950 rpm speed for server and precision cooling. Its PDF lists 30984 m3/h maximum airflow and 0-10V/PWM control for adjusting the fan speed.
Read More
GTW071PUT23E is a nominal 400VAC EC axial fan for server and precision cooling. Its PDF specifies an IP54 rating and RS485 Modbus control, with 23134 m3/h maximum airflow at the documented 1250 rpm setup.
Read More
GTW080PUR22E offers EC axial fan airflow for server and precision cooling at nominal 400VAC. The PDF specifies 0-10V/PWM and RS485 control, with 25077 m3/h maximum airflow and a rated 1020 rpm speed.
Read More
GTW050EUD19E is listed as an EC axial fan for server and precision cooling on single-phase 200-277VAC. The supplied 497 mm size and 1500 rpm speed accompany a maximum airflow specification of 9046 m3/h.
Read More